![]() ![]() timing pin engages on L 2400 EB1.AD engines).Ĭaution: If the engine is equipped with a vacuum pump, turning of the engine against its rotation sense must be reduced to the absolute minimum.Ĥ.Remove ignition harness from the magneto. 30°) and thereafter rotate the engine backwards to the firing position (timing mark and crankcase parting surface line up resp. Turn engine slowly until the impulse coupling of the magneto “snaps” (apprx. If this is not the case rotate theĬrankshaft one full revolution. The valves of the no.2 cylinder must either be crossing over or the no.1 cylinder must be at the end of it’s compression cycle (feel pressure buildup by closing the spark plug bore of the no.1 cylinder by closing it with your thumb while rotating the crankshaft). ![]() starter ring gear lines up with the parting surface of the crankcase (on the L 2400 EB1.AD the timing pin P/N: 803.001.125 fits through a bore in the accessory case and must engage with a notch in the fly-wheel). Rotate the engine at the crankshaft until the timing mark on the propeller hub resp. ![]() Most Grob 109 aircraft fitted with Limbach engines use a 4230 Slick Magneto Removal – and installation of magnetoĢ.Remove high tension leads from the spark plugs.ģ.Rotate engine to firing position as follows: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |